Land Pride OS1548 Operator's Manual page 51

Section 4: Maintenance & Lubrication
OS1548 2-Plate Disassembly
Step 1
Remove snap ring.
Step 2
Remove backup ring, lock collar,
compression spring, bottom backup
ring, and balls.
Step 3
Tighten the four hex nuts uniformly
until the clutch pack and hub are
loose.
Step 4
Bend all four retaining lugs out on
edge of clutch housing.
Step 5
Remove thrust plate with Belleville
Springs and lug rings to access
friction discs and hub for inspection or
service.
Step 6
Inspect friction discs and hub.
10435
11/28/18
Table of Contents
10449
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
OS1548 2-Plate Assembly
Step 1
Place hub and friction discs into the
housing.
Step 2
Compress Belleville Springs to the
pressure plate by tightening the four
hex nuts and then placing the
assembly into the clutch housing.
Step 3
Bend retaining lugs inward over the
Belleville Spring edges to secure the
spring before backing the four hex
nuts off.
Step 4
With lugs bent in, loosen the four hex
nuts completely to the end of the
threaded studs.
Step 5
Insert greased balls.
Step 6
Install bottom backup ring,
compression spring, lock collar, and
top backup ring.
Step 7
Install snap ring.
47