ATCA-9100 MRM Installation Guide
5. Enter the
If you are asked to save changes, enter
configuration will be saved as the startup configuration.
6. Enter the
Enable or disable specific ports
Note: RadiSys recommends having only one backplane port enabled on the MRM Base interface
if the shelf has two hub modules with interconnected Base switching domains. By default,
RadiSys hub modules connect their Base switching domains. If the Fabric switching domains are
also interconnected (which they are not by default on RadiSys hub modules), only one backplane
port on the MRM Fabric interface should be enabled.
1. Verify you are at the applicable switch prompt.
Switch
Base Ethernet
Fabric Ethernet
If you are not at the appropriate prompt, see View port status on page
how to get there.
2. Use these steps to enable or disable specific ports:
a. Enter this command.
configure
b. Enter the specific port (interface) number to enable.
interface
Where
Backplane slots
DSPs 1-10
DSPs 11-20
Local management processor (LMP)
RTM
c. Enter this command to enable a port:
no shutdown
If you are disabling the interface, enter
8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
command to return to the
exit
command to log off the module.
exit
<s>/<p>
and
have the following values.
<s>
<p>
prompt.
ATCA‐9100#
for yes or
for no. If you choose
y
n
Prompt
ATCA‐9100‐Base#
ATCA‐9100‐Fabric#
s=0
p=1-2
s=2
p=1-10
s=1
p=1-10
s=3
p=1
s=4
p=1
.
shutdown
for yes, this
y
7 for instructions on