Table of Contents
Advertisement
Installation and Set-Up
14. Electrical Connection
The electrical control box (mounted on the lower
right side of the machine frame), contains the
pre-set circuit breaker. The box can be
relocated to the other side of the machine if
desired. A standard three conductor power cord
with plug is provided at the back of the electrical
control box for 115 V , 60 Hz, 2.8 Amp electrical
service. The receptacle providing this service
shall be properly grounded. Before the power
cord is plugged into 115 Volt, 60 Hz outlet make
sure that all packaging materials and tools are
removed from the machine. Do not plug
electrical cord into outlet until ready to run
machine.
Use of an extension cord is not recommended.
However, if one is needed for temporary use, it
must have a wire size of 1.5 mm diameter
[AWG 16 ], have a maximum length of 30.5 m
[100 ft], and must be properly grounded.
WARNING – To prevent shock and
fire hazard: Position extension cord
where it will be out of the way of foot or
vehicle traffic. Extension cord is only for
temporary use – do not use for a
permanent installation.
Note – Machines outside the U.S. may be
equipped with 220/240 Volt, 50 Hz systems
or other electrical requirements compatible
with local practice.
15. Continue with the remainder of the Installation
and Set-Up procedure on this page.
(Continued)
15
TAPING HEADS
Tape Width – the taping heads have been pre-set to
accommodate 72 mm [3 inch] wide tape rolls. To
apply 48 mm [2 inch] wide tape, refer to Section II,
"Adjustments – Tape Web Alignment", page 11.
Tape Leg Length – taping heads are pre-set to apply
70 mm [2.75 inch] long tape legs. To change tape
legs to 50 mm [2.0 inch], refer to Section II,
"Adjustments – Changing Tape Leg Length",
page 13.
BOX SIZE CAPACITY OF CASE SEALER
At its factory setting, the case sealer handles
box sizes up to 510 mm [20 inch] maximum
height. If larger capacity is needed, the machine
can be adjusted to accommodate boxes up to
615 mm [24.25 inch] high. Refer to "Special
Set-Up Procedure – Outer Column
Re-Positioning", page 34. Note – Adjusting
machine to accommodate 615 mm
[24.25 inch] high boxes also increases
minimum box size to 205 mm [8.0 inch].
INITIAL START-UP OF CASE SEALER
After completing the "Installation and Set-Up"
procedure, continue through "Operation" for tape
loading and start-up to be sure case sealer is
properly adjusted to run boxes
Advertisement
Table of Contents
