Charging Station - Husqvarna Automower 405X Workshop Manual

5. Remove the wheel. Refer to
wheels on page 31 .
6. Remove the 4 screws for the wheel motor.
7. Remove the wheel motor.
8. Install the new wheel motor.
9. Install in opposite sequence.
6.18.4 To install or replace the wheel brushers
1. Remove the top cover. Refer to
install the top cover on page 19 .
2. Remove the wheel brush holders. Lift the clips on
the wheel brush holder and push forward.
32 - Repair instructions
To replace the rear
To remove and
3. Insert the wheel brush in the slot from below in an
angle (A) and push it down into position (B). As an
alternative, insert the wheel brush from the above in
an angle (C) and push it down into position (D).
A
B
4. Install in the opposite sequence.

6.19 Charging station

The charging station consists of a baseplate and a
charging tower with the charging station's circuit board
and the contact plates. When the product's battery does
not recharge or cannot contact the charging station this
may be due to worn contact plates in the charging
station. Also check the charging plates on the product.
6.19.1 To remove and install the charging station
and the charging station cap
This section gives information on how to remove all
parts of charging tower. For service or to replace spare
parts all steps may not be needed.
1. Disconnect the power supply.
2. Push the button and tilt the charging station cap.
3. Disconnect all cables from the charging station.
C
D
1582 - 001 - 23.12.2020