Husqvarna Automower 405X Workshop Manual page 43

Messages
Number Message
27 Settings restored
28 Electronic problem
29 Slope too steep
30 Charging system problem
32 Tilt sensor problem
33 Mower tilted
35/36 Wheel motor overloaded, right/left Grass or other object has wrap-
37 Charging current too high
1582 - 001 - 23.12.2020
Cause
When restoring user settings af-
ter, e.g circuit board replacement,
user settings failed to save and
the product has been reset to fac-
tory settings.
Confirmation that Reset all user
settings has been carried out.
Memory data error.
Mower stopped because the
slope is too steep.
Battery not connected properly, or
faulty.
Wrong type of battery.
The tilt sensor has invalid values. Calibrate the tilt sensor. Refer to
The product is tilted more than
the maximum angle.
ped around the drive wheel.
The battery is being charged with
too high current.
Action
If the fault occurs repeatedly, pro-
gram the product with the most
recent main program. Refer to
Firmware on page 16 .
If the fault occurs repeatedly,
even using the most recent main
program, replace the motor con-
trol circuit board. Refer to
place the motor control circuit
board on page 26 .
This is normal. No action re-
quired.
Program the product with the
most recent main program. Refer
Firmware on page 16 .
to
Replace the motor control circuit
To replace the
board. Refer to
motor control circuit board on
page 26 .
Calibrate the tilt sensor. Refer to
Tools - Calibrate on page 13 .
Change the installation of the
boundary wire to exclude this
steep part of the work area. Refer
To examine where to put the
to
boundary wire in the Operator's
manual.
Check that the battery is properly
The battery
connected. Refer to
system on page 29 .
Use only original batteries recom-
mended by the manufacturer.
Tools - Calibrate on page 13 .
Replace the motor control circuit
board. Refer to To replace the
motor control circuit board on
page 26 .
Move the product to a flat area.
Check the drive wheel and re-
move any objects.
Fault in the power supply, or
wrong type of power supply or
charging station is being used.
Troubleshooting- 43
To re-