Husqvarna Automower 405X Workshop Manual page 33

4. Remove the 2 screws on the front of the charging
station.
5. Carefully lift the charging cover forward and upward
from the charging tower.
A
6. Disconnect the charging cable.
7. Remove the 4 screws from underneath the
baseplate to remove the charging tower.
1582 - 001 - 23.12.2020
8. Disconnect the cables to the cable plate.
9. Remove the charging tower from the baseplate.
10. Install in opposite sequence.
B
6.19.2 To replace the circuit board in the charging
station
1. Remove the charging tower and charging station
cap. Refer to
station and the charging station cap on page 32 .
2. Disconnect the cables from the circuit board.
3. Push the 2 clips to remove the circuit board.
4. Attach the new circuit board.
Note: Make sure that the cables to the power supply
are in the cable holders behind the circuit board.
5. Reconnect the cables to the new circuit board.
6. Install in opposite sequence.
To remove and install the charging
Repair instructions- 33