Table of Contents
Advertisement
5 OPERATION
5.5
Remote control for digital wire feeder
It is possible to adjust the maximum value on the remote control output (0-10 V) both for wire
feed speed and voltage. The maximum value is 0.5 V lower than V
voltage drop in the opto driver.
Set Wire Feed Speed (WFS)
1.
Press Menu once.
The display shows: DigF max WFS
2.
Press + or - to adjust the setting.
Scale value: 1 - 40
Higher value gives higher output.
Set Voltage (V)
1.
Press Menu until DigF max V is shown in the
display.
2.
Press + or - to adjust.
Scale value: 1 - 40
Higher value gives higher output.
5.6
Installation of wire feeder
The installation must be carried out by a professional.
Railtrac™ BV2000 can be connected to one of the following wire feed units:
Aristo® Feed 3004, Aristo® Feed 4804, Origo™ Feed 304, Origo™ Feed 484 and
Warrior™ Feed 304.
For necessary adaptation between Railtrac™ BV2000 and the used wire feed unit (including
choice of control cable), see the "ACCESSORIES" appendix to this manual.
Universal feeder connection
For the operation of Railtrac™ BV2000 from other wire feeders (none ESAB), use
transformer unit and control cable according to the "ACCESSORIES" appendix.
0463 629 001
- 19 -
(10 V) due to the
in
© ESAB AB 2018
Advertisement
Table of Contents
