Table of Contents
Advertisement
Start Up
7.
Prime the pump with disinfectant as
follows:
a.
Verify Prime Knob on sprayer is
pointed down to PRIME position.
b.
Install a fully charged battery into
the sprayer.
c.
Set Speed Control on sprayer to
10.
d.
Turn Valve Handle
counter-clockwise to open position.
e.
Verify Spray Tip is forward in the
SPRAY position. Turn Prime Knob
on sprayer forward to SPRAY
position.
6
f.
Turn sprayer upside down. Pull the
trigger and spray for 5 seconds. If
sprayer does not spray within 5
seconds, STOP and repeat
Starting a New Job, page 4.
NOTE: Sprayer must spray disinfectant for 5
seconds to be primed before proceeding to
step 8.
NOTICE
Do not run sprayer without fluid. Running
the sprayer dry will cause damage to the
pump.
8.
You are now ready to spray!
Backpack Strap
Adjustment
For best results, make strap adjustments
while wearing ProPack full of disinfectant.
ProPack should fit comfortably on lower
back, and still allow enough free movement to
easily operate equipment.
3A8304B
Advertisement
Table of Contents
