Back Panel Block - Sony STR-DN1080 Service Manual

2-12. BACK PANEL BLOCK

Note 1: During reassembly, use new cable ties
to fasten the wires back in place as
they were before disassembly.
7 back panel block
3 five screws
(BVTP3 8)
5 screw
(See Note 2)
3 two screws
(BVTP3 8)
5 screw
(See Note 2)
(US, CND)
3 screw
3 screw
(BVTP3 8)
Note 2: Screw used differs depending on destination and model.
Refer to "7. EXPLODED VIEWS" on page 85.
6 claw
rear side
(DN1080)
(BVTP3 8)
4 four screws
(See Note 2)
• Power cord (DN1080) or AC inlet cable (ZA810ES) setting
(DN1080: US, CND)
rear side
cable tie
STANDBY board
(DN1080: AEP, UK, AUS, TW)
rear side
cable tie
STANDBY board
6 claw
(ZA810ES)
3 three screws
(BVTP3 8)
(ZA810ES)
CNP901
Press.
rear side
claw side
CNP901
Press.
claw side
STR-DN1080/ZA810ES
Ver. 1.1
front side
2 power cord (DN1080) or
AC inlet cable (ZA810ES)
connector (CNP901)
1 Cut the cable tie.
CNP901
Press.
cable tie
claw side
STANDBY board
21
SYS SET