Sony STR-DN1080 Service Manual page 3

(STR-ZA810ES)
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from 20 Hz – 20,000 Hz; rated
90 watts per channel minimum RMS power, with no more than 0.09%
total harmonic distortion from 250 milliwatts to rated output.
1) 2)
Amplifier section
Rated Power Output at Stereo Mode
(6 ohms, 20 Hz – 20 kHz, THD 0.09%): 90W + 90 W
Reference Power Output at Stereo Mode
(8 ohms, 20 Hz – 20 kHz, THD 0.09%): 70W + 70 W
Reference Power Output
(6 ohms, 1 kHz, THD 0.9%)
FRONT: 110 W + 110 W
CENTER: 110 W
SURROUND: 110 W + 110 W
SURROUND BACK: 110 W + 110 W
Reference Power Output
(8 ohms, 1 kHz, THD 0.9%)
FRONT: 100 W + 100 W
CENTER: 100 W
SURROUND: 100 W + 100 W
SURROUND BACK: 100 W + 100 W
Reference Power Output at Surround Mode 3)
(6 ohms, 1 kHz, THD 0.9%): 140 W per channel
1) Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
2)
Depending on the sound field settings and the source, there may be
no sound output.
3) Reference power output for front, center, surround, surround back
speakers.
Frequency response
Analog
10 Hz – 100 kHz, ±3dB (When [Direct] is being used and an analog
input is selected.)
Input
Analog
Sensitivity: 500 mV/50 kilohms
S/N 4) : 105 dB (A, 500 mV 5) )
Digital (Coaxial)
Impedance: 75 ohms
S/N: 100 dB (A, 20 kHz LPF)
Digital (Optical)
S/N: 100 dB (A, 20 kHz LPF)
Output (Analog)
ZONE 2
Voltage: 2 V/1 kilohm
SUBWOOFER
Voltage: 2 V/1 kilohm
Equalizer
Gain levels
±10 dB, 1 dB step
4) INPUT SHORT (with sound field and equalizer bypassed)
5) Weighted network, input level
FM tuner section
Tuning range
87.5 MHz – 108.0 MHz (100 kHz step)
Antenna (aerial)
FM wire antenna (aerial)
Antenna (aerial) terminals
75 ohms, unbalanced
Video section
Inputs/Outputs
Video: 1 Vp-p, 75 ohms
HDMI Input/Output (HDMI Repeater block)
The HDMI OUT and HDMI IN jacks (except the HDMI IN VIDEO 1 jack)
support bandwidth up to 18 Gbps. The HDMI IN VIDEO 1 jack
supports bandwidth up to 9 Gbps.
All HDMI jacks on the receiver support 4K, HDCP 2.2, ITU-R BT.2020
wide color spaces, 3D, Deep Color (Deep Colour), and HDR (High
Dynamic Range) contents pass-through.
The HDMI OUT A (TV) jack supports eARC and ARC.
HDCP 2.2 is newly enhanced copyright protection technology that
is used to protect content such as 4K movies.
BT.2020 color space is new wider color standard that is defined for
ultra-high definition television systems.
HDR is an emerging video format that can display a wider range of
brightness levels. This receiver supports HDR10, HLG (Hybrid Log-
Gamma), and Dolby Vision.
Supported video formats
Format 2D
Frame
packing Side (Half)
4096 × 2160p @ 59.94/60 Hz *
4096 × 2160p @ 50 Hz *
4096 × 2160p @ 29.97/30 Hz **
4096 × 2160p @ 25 Hz **
4096 × 2160p @ 23.98/24 Hz **
3840 × 2160p @ 59.94/60 Hz *
3840 × 2160p @ 50 Hz *
3840 × 2160p @ 29.97/30 Hz **
3840 × 2160p @ 25 Hz **
3840 × 2160p @ 23.98/24 Hz **
1920 × 1080p @ 59.94/60 Hz
1920 × 1080p @ 50 Hz
1920 × 1080p @ 29.97/30 Hz
1920 × 1080p @ 25 Hz
1920 × 1080p @ 23.98/24 Hz
1920 × 1080i @ 59.94/60 Hz
1920 × 1080i @ 50 Hz
1280 × 720p @ 59.94/60 Hz
1280 × 720p @ 50 Hz
1280 × 720p @ 29.97/30 Hz
1280 × 720p @ 23.98/24 Hz
720 × 480p @ 59.94/60 Hz
720 × 576p @ 50 Hz
640 × 480p @ 59.94/60 Hz
* If you use YCbCr 4:4:4/YCbCr 4:2:2/RGB 4:4:4 or YCbCr 4:2:0 deep
color (10 bit or 12 bit) of these video formats, be sure to use HDMI IN
jacks except the HDMI IN VIDEO 1 jack, and Premium High Speed HDMI
Cables with Ethernet, which can support bandwidth up to 18 Gbps.
** If you use deep color (10 bit or 12 bit) of these video formats, be sure
to use HDMI IN jacks except the HDMI IN VIDEO 1 jack, and Premium
High Speed HDMI Cables with Ethernet, which can support bandwidth
up to 18 Gbps.
Supported digital audio formats
Maximum number
Digital audio format of decoded
channels
Dolby Digital [DOLBY D] 5.1
1)
Dolby Digital Plus [DOLBY D +] 7.1
1)
Dolby TrueHD [DOLBY HD] 7.1
Dolby Atmos - Dolby Digital Plus 5.1.2, 7.1 or 7.1.2 3)
[DAtmos] 1), 2)
Dolby Atmos - Dolby TrueHD 5.1.2, 7.1 or 7.1.2 3)
1), 2)
[DAtmos]
D S T D [ T ] S 5.1
DTS-ES Discrete [DTS-ES Dsc] 6.1
DTS-ES Matrix [DTS-ES Mtx] 6.1
DTS 96/24 [DTS 96/24] 5.1
DTS-HD High Resolution Audio 7.1
1)
[DTS-HD HR]
DTS-HD Master Audio [DTS-HD
7.1
MA] 1)
DTS:X [DTS:X] 1) 5.1.2, 7.1 or 7.1.2 3)
1) 3)
DTS:X Master Audio [DTS:X MA] 5.1.2, 7.1 or 7.1.2
1), 4)
DSD [DSD] 5.1
1)
Multi Channel Linear PCM [PCM] 7.1
1) Audio signals are output in another format if the playback device does
not correspond to the actual format. For details, refer to the operating
instructions of the playback device.
2) Dolby Atmos is decoded as Dolby Digital Plus or Dolby TrueHD if the
speaker pattern is set to 2.0, 2.1, 3.0, 3.1, 4.0, 4.1, 5.0 or 5.1.
3)
Available only when [SpeakerRelocation/PhantomSurroundBack] is
set to [Type A] or [Type B].
4) This format is not output to wireless headphones.
iPhone/iPad/iPod section
iPhone 6s, iPhone 6s Plus, iPhone 6, iPhone 6 Plus, iPhone 5s, iPhone 5c,
iPhone 6s Plus, iPhone 6s, iPhone 6 Plus, iPhone 6, iPhone 5s, iPhone 5c,
iPhone 5, iPhone 4s, and iPod touch (5th and 6th generation).
AirPlay works with iPhone, iPad, and iPod touch with iOS 4.3.3 or later,
Mac with OS X Mountain Lion or later, and PC with iTunes 10.2.2 or later.
You can use "SongPal" app with this receiver via BLUETOOTH or network
connection.
iPhone/iPad/iPod playback via (USB) port is not possible.
USB section
(USB) port:
Type A (For connecting USB flash drive)
Maximum current
1 A
Network section
Ethernet LAN
100BASE-TX*
Wireless LAN
Compatible standards: IEEE 802.11 a/b/g/n
Security: WPA/WPA2-PSK, WEP
Radio frequency: 2.4 GHz, 5 GHz
* We recommend using a Category 7 cable.
STR-DN1080/ZA810ES
Playable types of audio files
3D
Codec
Over-Under
MP3 (MPEG-1 Audio Layer III)
Side-by-
(Top-and-
1), 2)
AAC/HE-AAC
Bottom)
WMA9 Standard 2)
3), 4)
WMA10 Pro
LPCM 1)
FLAC 2)
Dolby Digital 1), 3)
DSF 2)
2), 5)
DSDIFF
AIFF 2)
2)
ALAC
V o b r s i
Monkey's Audio
1) The receiver can play ".mka" files. These files cannot be played on a
home network server.
2)
The receiver may not play this file format on a home network server.
3)
The receiver does not play this file format on a home network server.
4) The receiver does not play Lossless coded files.
5) The receiver does not play DST encoded files.
Notes
Some files may not play depending on the file format, the file encoding,
the recording condition, or the home network server condition.
Some files edited on a PC may not play.
Fast forward or fast reverse may not be available with some files.
The receiver does not play coded files such as DRM.
The receiver can recognize the following files or folders in USB devices:
up to folders in the 9th layer (including the root folder)
up to 500 files/folders in a single layer
The receiver can recognize the following files or folders stored in the
home network server:
up to folders in the 19th layer
up to 999 files/folders in a single layer
Some USB devices may not work with this receiver.
The receiver can recognize Mass Storage Class (MSC) devices (such as
flash drive or an HDD) and 101-key keyboards.
BLUETOOTH section
Connection with
Communication system
the receiver
BLUETOOTH Specification version 4.1
Output
COAXIAL/OPTICAL,
BLUETOOTH Specification Power Class 1
HDMI, eARC, ARC
Maximum communication range
HDMI, eARC, ARC
Line of sight approx. 30 m (98.4 feet)
HDMI, eARC
Frequency band
2.4 GHz band (2.4000 GHz – 2.4835 GHz)
HDMI, eARC, ARC
Modulation method
FHSS (Freq Hopping Spread Spectrum)
HDMI, eARC
Compatible BLUETOOTH profiles
A2DP 1.2 (Advanced Audio Distribution Profile)
COAXIAL/OPTICAL,
AVRCP 1.5 (Audio Video Remote Control Profile)
HDMI, eARC, ARC
3)
Supported Codecs
COAXIAL/OPTICAL,
SBC 4) , AAC, LDAC
HDMI, eARC, ARC
Transmission range (A2DP)
COAXIAL/OPTICAL,
20 Hz – 40,000 Hz (LDAC sampling frequency 96 kHz with 990 kbps
HDMI, eARC, ARC
transmission)
COAXIAL/OPTICAL, 20 Hz – 20,000 Hz (Sampling frequency 44.1 kHz)
HDMI, eARC, ARC
1) The actual range will vary depending on factors such as obstacles
HDMI, eARC
between devices, magnetic fields around a microwave oven, static
electricity, cordless phone, reception sensitivity, antenna's
HDMI, eARC
performance, operating system, software application, etc.
2) BLUETOOTH standard profiles indicate the purpose of BLUETOOTH
HDMI, eARC
communication between devices.
HDMI, eARC
3)
Codec: Audio signal compression and conversion format
HDMI
4) Subband Codec
HDMI, eARC
General
Power requirements
120 V AC, 60 Hz
Power consumption
240 W
Standby mode: 0.5 W
(When [Control for HDMI], [Standby Through], [Remote Start],
[Bluetooth Standby], [Network Standby] and all zone power are set to
[Off].)
Bluetooth Standby mode: 2.5 W
(When [Bluetooth Standby] is set to [On], and [Control for HDMI],
[Standby Through], [Remote Start], [Network Standby] and all zone
power are set to [Off].)
Dimensions (Approx.)
430 mm × 156 mm × 331 mm (17 in × 6
depth) including projecting parts and controls
Mass (Approx.)
9.1 kg (20 lb 1 oz)
Supplied accessories
Operating Instructions
Startup Guide (1)
Calibration microphone (1)
FM wire antenna (aerial) (1)
AC power cord (mains lead) (1)
Remote control (1)
R03 (size AAA) batteries (2)
Design and specifications are subject to change without notice.
Extension
1) .mp3
3) 3) 3)
.m4a, .aac , .mp4 , .3gp
.wma
.wma
.wav
.flac, .fla
.ac3
.dsf
.dff
.aiff, .aif
.m4a
.ogg
.ape
1)
2)
1 / in × 13 1 / in) (width/height/
4 8
3
SYS SET