Chassis (Op, Za) Complete Assy (Op1); Panel (Back) Block - Sony XAV-601BT Service Manual

3-14. CHASSIS (OP, ZA) COMPLETE ASSY (OP1)

A
tension spring (KF)
B
Hang in order of A, B by pay
attention spring of direction.

3-15. PANEL (BACK) BLOCK

OK
sheet (screw)
3 screw (M2)
(2
4 two screws (T)
(2
Note: If the installation position of a screw (T) and a screw (M2) is mistaken, liquid
crystal display panel (LCD1) and touch panel (TPN1) are sometimes damaged.
Be sure to install after checking the kind and installation position of a screw.
9 chassis (OP, ZA) complete assy (OP1)
2 sled motor flexible board
(CN1)
7 compression spring
(damper, Z)
4 Turn the gear (RA1) fully
in the direction of arrow A.
A
NG
sheet (screw)
2 two screws
9 panel (back) block
8, Black)
4, Black)
4 screw (T)
(2 4, Black)
3 screw (M2)
(2 8, Black)
4 screw (T)
(2 4, Black)
1 OP flexible board (CN2)
Note: When disconnecting the OP flexible board
8 label (S)
1 two sheets (screw)
(S1.7 4)
6
2 three screws
(S1.7
1 three sheets
(screw)
7 spring
3 screw (M2)
(2 8, Black)
– Front panel block rear side view –
XAV-601BT
from of the connector. Be sure to refer to
"NOTE FOR FLEXIBLE BOARD OF THE
OPTICAL PICK-UP" of the servicing notes
(See page 6).
5
6 two coil springs
(damper)
3 tension spring (KF)
5 six claws
4)
8 button
(release)
(release)
25