STR-DN1080/ZA810ES
2-25. MAIN BOARD SERVICE POSITION (Check the SIDE A removing the back panel)
Clamp to the HDMI connector (CN5000).
("GAME" port)
MB-1613 board
alligator clip
Clamp to the GND plate.
Clamp to the
chassis.
GND BRACKET board
(DN1080)
2-26. MAIN BOARD SERVICE POSITION (Check the SIDE B without removing the back panel)
Clamp to the back panel.
(STR-DN1080)
front side
Clamp to
the chassis.
bottom side
alligator clip
Note 1: If removing the power cord from the back panel is difficult,
prepare a new power cord and connect it to the STANDBY
board. Refer to page 85 or page 95 for the Part No. of the
power cord.
30
DCDC board
STANDBY board
(ZA810ES)
back panel
MAIN board
STANDBY
board
rear side
alligator clip
top side
power transformer
Clamp to the back panel.
(STR-ZA810ES)
front side
Clamp to
the chassis.
bottom side
alligator clip
Note 2: Remove the AC inlet from the back panel and then
directly reconnect it to the STANDBY board.
front panel block
Clamp to the GND plate.
front side
bottom side
MAIN board
back panel
MAIN board
STANDBY
board
rear side
SYS SET