Maintaining Your Vacuum; Emptying The Dust Cup; Removing And Cleaning The Dust Cup; Cleaning The Filters - Shark Anti Hair Wrap & DuoClean IZ201EU Series Instructions Manual

MAINTAINING YOUR VACUUM

EMPTYING THE DUST CUP

Press the handvac release button and disconnect
the handheld vacuum from the wand.

REMOVING AND CLEANING THE DUST CUP

To remove the dust cup from the handheld vacuum,
press the Dust Cup Release button near the handheld
vacuum nozzle. Tilt the dust cup and lift off to remove.
To empty dust and debris, hold the dust cup over the
trash, then slide the Lid Release slider forward.
48
0800 862 0453
1
To empty the Dust Cup while it is attached to the
handheld vacuum, position the dust cup over a trash
receptacle and slide the Lid Release slider forward.
1
Remove debris from the dust screen by tapping it
gently or wiping it with a dry cloth as needed. To
clean the interior of the dust cup, rinse it with water.
Place it on its side to air-dry for at least 24 hours
before reinstalling.
To clean filters, rinse them with water only. Allow all filters to air-dry completely for at least 24 hours
2
before reinstalling to prevent liquid from being drawn into electric parts. Clean the pre-motor filters at
least once a month and post-motor filter at least once a year. Tap off loose dirt between washes when
needed. More frequent cleaning may sometimes be necessary with heavy use.
IMPORTANT: DO NOT use soap when cleaning the filters. Use water only.
PRE-MOTOR FILTER
Press the dust cup release button and remove the
2
dust cup. Pull the foam and felt filters out of the
back of the dust cup.
Pre-Motor Foam and
Felt Filter Kit
NOTE: To order filters and other parts, visit sharkclean.eu
MAINTAINING YOUR VACUUM

CLEANING THE FILTERS

POST-MOTOR FILTER
Remove the dust cup. Pull the post-motor filter out
of the handheld vacuum.
Post-Motor Filter Post-Motor
Filter
49
s h a r kc l e a n . e u