Floor Nozzle; Checking For Blockages - Shark Anti Hair Wrap & DuoClean IZ201EU Series Instructions Manual

MAINTAINING YOUR VACUUM

FLOOR NOZZLE

If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages
or objects caught in the brush-roll.
ANTI-HAIR WRAP FLOOR NOZZLE
1. Turn off the vacuum.
2. Using a coin, turn locks counterclockwise to open, then lift off cover to access brush-roll.
3. Clear airway of blockages.
4. Replace cover by sliding inserts into slots, then pressing down firmly on all sides before turning
locks clockwise to close. There will be an audible click once the locks are secured.
50
0800 862 0453
MAINTAINING YOUR VACUUM

CHECKING FOR BLOCKAGES

Checking for Blockages in the Handheld Vacuum:
1. Turn off vacuum.
2. Remove the handheld vacuum from the wand.
3. Check all intake openings to the dust cup and
remove any debris or blockage.
Checking for Blockages in the Wand:
Flexology® Wand:
1. Turn off vacuum.
2. Remove the handheld vacuum and floor nozzle
from the wand.
3. Check the clog access on the Flexology® portion
of the wand by pinching the tabs on either side of
the hose and lifting the hose out for wand access.
4. Clear any debris and blockages.
Checking for Blockages in the Floor Nozzle:
1. Turn off vacuum.
2. Detach the wand.
3. Use the edge of a coin to open the three locks
on the bottom of the floor nozzle (see page 12).
4. Remove the cover and tilt back the neck of the
floor nozzle.
5. Check the opening and remove any debris or blockage.
6. Replace cover by firmly pressing down on all sides and
turn the locks clockwise.
51
s h a r kc l e a n . e u