XYZ Printing PartPro200 xTCS User Manual page 12

Function Operation and Instructions
C2-1 Ink Calibration
We suggest you print a test page after you install the ink cartridge. Please prepare a sheet of paper.
1. Tap Calibration.
4. Take out the EZ Removable
Rubber Magnet. Use tape to
secure the A4 in the portrait
direction on the front side of the
rubber magnet.
7. Put the rubber magnet back
to print bed accordingly.
C2-1 Ink Calibration
1. You can also choose to print
the "PLA Test Page" to confirm
the ink status.
5. Confirm if the print job is
completed.
Test Page Paper Test Page
2. Tap Test Page.
5. Tighten/pull the A4 paper so
it is flat(no gap) on the rubber
magnet.
8. Fix the paper onto the print
bed and then tap PROCEED,
the printer will do a test print.
Test Page PLA Test Page
2. Tap "PLA Test Page" to print.
6. Taken off the printing object
and check the coloring status.
3. Test Page.
6. Fold tightly the excess A4 paper to the back of the rubber
magnet.
9. Remove the test page and
tap PROCEED.
3. Wait for the extruder to heat
up to operating temperature.
4. Printing "PLA Test Page".
P12 P12