Grandstream Networks GVC3212 Administration Manual page 24

Always send HTTP It is used to set if the device includes the credential information in the HTTP/HTTPS
request messages to download the cfg.xml file. If it is set to "Yes ", the credential
Basic
Authentication information will always be included in the HTTP/HTTPS messages regardless the
server's challenge. The default setting is "No".
Information
It is used to set the prefix characters for the configuration files. If it is configured, only
Config File Prefix the firmware with the matching encrypted prefix will be downloaded and flashed into
the device system.
XML Config File The password for encrypting the XML configuration file using OpenSSL. The
Password password is to decrypt the XML configuration file if it is encrypted via OpenSSL.
Provision
Automatic Upgrade
Specifies when the firmware upgrade process will be initiated; there are 4 options:
•
•
•
Automatic Upgrade
the week (0-6)".
•
upgrade (in minutes) and specify "Hour of the day (0-23)"
Note: Day of week is starting from Sunday. The default setting is "No".
Setting whether to upgrade automatically at random. It means whether the device will
Enable Randomized
upgrade automatically at random time point in the setting period. This option is mainly
Automatic Upgrade
used for multiple devices upgrade at the same time.
Defines the hour of the day (0-23) to check the HTTP/TFTP server for firmware
Automatic Upgrade
upgrades or configuration files changes. This option is available when "Automatic
Check interval (m)
Upgrade" is set to "Check Every Interval ". The default setting is "10080".
It is used to define the rules for automatic upgrade on the device.
It can be selected from the following:
Firmware Upgrade
 Always Check at bootup
and Provisioning
 When F/W pre/suffix changes,
 Skip the Firmware Check.
If set to "No", the device will automatically start upgrading after downloading the
Upgrade With
firmware files. Otherwise, users would need to confirm in the prompted message
Prompt
before upgrading process is started. The default value is "Yes".
DHCP option
If set to "Yes" on the LAN side, the device will reset the CPE, upgrade, network VLAN
tag and priority configuration according to option 43 sent by the server. At the same
Allow DHCP Option
time, the upgrade mode and server path of the configuration upgrade mode will be
43, 160 and 66 to
reset according to option 160 and 66 sent by the server. If set to "Prefer, fallback when
Override Server
failed", the device can fallback to use the configured provisioning server under its
Firmware and Config server path in case the server from DHCP Option fails.
No: The phone will only do upgrade once at boot up.
Check every day: User needs to specify "Hour of the day (0-23)".
Check every week: User needs to specify "Hour of the day (0-23)" and "Day of
Check Every Interval: User need to specify the time period to check for firmware
GVC3212 Administration Guide
Version 1.0.1.6
P a g e | 24