Grandstream Networks GVC3212 Administration Manual page 17

Layer 2 QoS It is used to define the Priority Code Point within a Layer 2 frame header. The valid
range from 0 to 7. The Default value is 0 which is equivalent to the Routine class for
802.1p Priority
value (Ethernet) the Class of Service.
It is used to configure the device's static IP address if the static IP is used.
IP Address
It is used to configure the network's subnet mask if the static IP is used.
Subnet Mask
It is used to configure the network's gateway address if the static IP is used.
Gateway
It is used to configure the primary DNS IP address if the static IP is used.
DNS Server 1
DNS Server 2 It is used to configure the secondary DNS IP address if the static IP is used.
PPPoE Account It is used to configure the PPPoE account ID if the PPPoE is used.
PPPoE Password It is used to configure the PPPoE password if the PPPoE is used.
IPv6
Allows users to choose whether to get automatically the IPv6 address from DHCP
IPv6 Address server (Auto-configured) or configure a static IPv6 address (Statically configured).
Default is Auto configured.
Preferred DNS
Enter the Preferred DNS server.
Server
Static IPv6
It is used to configure a static IPv6 address if Statically configured is used.
Address
IPv6 Prefix
It is used to set the IPv6 prefix length if Statically configured is used. Default is 64.
Length
DNS Server 1 It is used to configure the primary DNS IP address if Statically configured is used.
It is used to configure the secondary DNS IP address if Statically configured is used.
DNS Server 2
Preferred DNS
It is used to configure the preferred DNS server.
Server
802.1x Mode
It is used to enable and select the 802.1x mode for the device. The supported 802.1x
modes are:

EAP-MD5
802.1x Mode

EAP-TLS

EAP-PEAP
The default setting is "Disable".
It is used to fill in the identity information for the selected 802.1x mode. This setting
802.1x Identity
will be displayed only if 802.1x mode is enabled.
It is used to enter the secret for the 802.1x mode. This setting will be displayed only if
802.1x Secret
the 802.1x mode is enabled.
It is used to enter the private key password for the 802.1x mode. This setting will be
Private Key
displayed only if the 802.1x mode is enabled.
It is used to upload the CA Certificate file to the device. This setting will be displayed
CA Certificate
only if the 802.1x mode is enabled.
GVC3212 Administration Guide
Version 1.0.1.6
P a g e | 17