Daikin BRC7M675 Operation & Installation Manual page 13

Movement of the airflow direction blades
Under the operating conditions described below,
airflow direction is controlled automatically, so it
may differ from the airflow direction displayed on
the remote controller.
• COOLING
Operation • AUTOMATIC
mode COOLING
• PROGRAM DRY
Air blows in the
automatic set
direction for a
period of time to
prevent
condensation on
the horizontal
blades.
Up and
• When operating
down
continuously at
direction
downward
airflow direction
Description of airflow direction settings
and operation
The range of movement of the airflow direction
blades varies by indoor unit model. Consult the
dealer of purchase for details.
Airflow
„ Wall mounted
direction
settings
The airflow direction can be fixed in
any position in the range Position 0
to Position 4.
Fixed
The airflow direction blades
automatically move up/down or left/
right within the range of Position 0
to Position 4.
Swing
• HEATING
• AUTOMATIC
HEATING
The airflow
direction becomes
horizontal so that
it does not blow
directly toward
your body.
• When room
temperature is
higher than the
set temperature
• When the
HEATING
OPERATION
starts or during
DEFROST
OPERATION
(if frost forms on
the outdoor unit)
Up/down airflow
Indoor unit
(Desired position)
Indoor unit
(Swing)
PROGRAM TIMER OPERATION
Operate in the following order.
• The timer is operated in the following two ways.
Programming the stop time ( OFF)
.... The air conditioner stops operating after the
set time has elapsed.
Programming the start time ( ON)
.... The air conditioner starts operating after the
set time has elapsed.
• The start and the stop time can be
simultaneously programmed.
• The timer setting is effective only once. When
using the TIMER operation every day, the
setting is required before each use.
Setting the timer
1
TIMER MODE ON/OFF
Press the TIMER MODE ON/OFF button.
The display flashes.
For setting the timer stop .... " OFF"
For setting the timer start .... " ON"
2
PROGRAMMING TIMER
Press the PROGRAMMING TIMER button
and set the time for stopping or starting the
air conditioner.
When this button is pressed, the
time advances by 1 hour.
When this button is pressed, the
time goes backward by 1 hour.
• Keep pressing the button to change the
setting time continuously.
• The timer can be programmed a maximum
of 72 hours.
3
TIMER RESERVE
Press the TIMER RESERVE button.
The timer setting procedure ends.
The display changes from flashing light to a
constant light.
• Make sure that the receiving tone of the
indoor unit makes a beeping sound.
If the receiving tone does not sound, cancel
the timer according to the steps below, and
then set the timer following steps 1 to 3
above again.
10