Nfc Tag - Epson TM-m30 Technical Reference Manual

Since is disconnected when this occurs, if the auto reconnect feature is not enabled, you need to
reconnect from the
When using the SDK from Epson, this connection process is not necessary.
The iOS application cannot receive the data sent from the printer
Situation
Although the printer sends data to the iOS device and the data is received by the iOS device, depending on the
combination of the iOS version and the iOS device, the iOS application may not be able to receive the data.
Conditions
This may occur in combinations of the following conditions.
• iOS version: 7.1, 7.1.1
• iOS device: iPhone 5s, iPhone 5c, iPhone 5, iPad Air, iPad mini 3, iPad (4th generation), iPad mini, iPod
touch (5th generation), iPhone 4s, iPhone 4, iPad (3rd generation), iPad 2
• Application processing: If the
Solution
The solution differs depending on the iOS device being used. See the following table.
iOS Device
iPhone 4s
iPhone 4
iPad (3rd generation)
iPad 2

NFC Tag

Transmission standard
Frequency
Memory
Transmission distance
• The transmission distance is an estimate that depends on our experiment conditions and is not a
guaranteed value.
• It varies based on the installation environment and target device.
settings screen on the iOS device.
port is closed and then reopened while the application is running.
This situation can be avoided by using one of the following methods.
• Using the ePOS-Print SDK for iOS which is included in the ePOS-Print SDK Release
14.06.30E or later package
• Using the Epson ePOS SDK for iOS
ISO14443 A
13.56 MHz
144 byte
Approximately 10 mm from the NFC installation location.
Solution
Appendix
117