Troubleshooting, Care And Maintenance; General Instructions; Faults And Fault Diagnosis - CARDIOSTRONG BALTIC Assembly And Operating Instructions Manual

5

TROUBLESHOOTING, CARE AND MAINTENANCE

5.1

General Instructions

⚠ WARNING
+ Do not make any improper changes to the equipment.
CAUTION
⚠
+ Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
࣑ ATTENTION
+ In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2

Faults and Fault Diagnosis

The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault
Display is blank/is not
working
Creaking noises
Grinding noises on
the guide rail
No pulse display
26
Cause
Batteries empty or loose
cable connection
Screw connections loosened
or too tight
Guide rail or rollers dirty or
guide rail dry
+ Sources of interference in
the room
+ unsuitable chest strap
+ Wrong position of chest
strap
+ Chest strap defective or
battery empty
+ Pulse display defective
Solution
Replace batteries or check cable
connections
Check screw connections
Clean the guide rail and then lubricate it
with a suitable lubricant
+ Eliminate sources of interference (e.g.
mobile phone, WLAN, lawn mower
and vacuum cleaner robot, etc. ...)
+ Use a suitable chest strap (see
RECOMMENDED ACCESSORIES).
+ Reposition chest
moisten electrodes
+ Changing batteries
BALTIC
strap and/or