Troubleshooting, Care And Maintenance; General Instructions; Faults And Fault Diagnosis - CARDIOSTRONG Baltic Pro Assembly And Operating Instructions Manual

5

TROUBLESHOOTING, CARE AND MAINTENANCE

5.1

General Instructions

⚠ WARNING
+ Do not make any improper changes to the equipment.
CAUTION
⚠
+ Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
࣑ ATTENTION
+ In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2

Faults and Fault Diagnosis

The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault
Heart rate is not
received
Display is not working
Creaking noises
Grinding noises on
the slide rail
30
Cause
+ Sources of interference in
the room
+ unsuitable chest strap
+ Wrong position of chest
strap
+ Batteries empty
+ Console has no power
supply
Loose screw connections
Slide rail not lubricated
Solution
+ Eliminate sources of interference
(e.g. mobile phones, loudspeakers,
WLAN, lawn mower and vacuum
cleaner robots ...)
+ Use a suitable chest strap (see
recommended accessories).
+ Reposition chest
moisten electrodes
+ Changing batteries
+ Hold Reset to start the console again.
+ Disconnect and connect again all
cable connections, see assembly
instructions.
Check the tightness of all screws.
Clean the slide rail with a towel (without
solvent!) and apply a small amount
of suitable lubricant to the slide rail.
Remove excess residue.
BALTIC PRO
strap and/or