Sony HXCU-FB80 Service Manual page 33

2. Remove the PS-934 board.
(1) Remove the four screws, then remove the PS-934 board.
(2) Remove the electric heat sheet (PS-R2) from the PS-934 board.
t
Route the harness to be connected to
CN006 so that its binding band is located
as shown in the illustration.
Harness
PS-934 board
CN006
Note
Carefully stick the electric heat sheet (PS-R2) to the new PS-934 board along lines (a) so as not to block the
two holes in the board.
3. Install the removed parts by reversing the steps of removal.
HXCU-FB80
Binding band
Clamper
Electric heat sheet
(PS-R2)
PS-934 board
PSW
3 x 6
Position of electric heat sheet (PS-R2)
Electric heat sheet
(PS-R2)
PS-934 board
a
Holes
3-5
a