Board - Sony HXCU-FB80 Service Manual

3-12. DPR-386 Board
Preparation
1. Remove the cover. (Refer to
2. Remove the AT-196 board. (Refer to
3. Remove the CN-3958 board. (Refer to
Procedure
1. Remove the DPR block.
(1) Disconnect the flexible flat cable (45 core) from the connector (CN3) on the DPR-386 board.
(2) Disconnect the four harnesses from the connectors (CN002 and CN005 to CN007) on the PS-934 board.
(3) Open the clamper, then remove the three harnesses.
(4) Remove the harness from the cord clamper.
(5) Remove the six screws, then remove the two AT brackets.
(6) Remove the eight screws, then remove the DPR block in the direction of the arrow.
PSW
3 x 6
Flexible flat cable
(45 core)
PSW
3 x 6
Harness
Cord clamper
HXCU-FB80
"3-2. Cover".)
"3-8. AT-196 Board and Lithium
"3-10. CN-3958
PSW
3 x 6
CN3
CN002 CN006
Clamper
Harnesses
Battery".)

Board".)

AT brackets
DPR-386 board
CN005
CN007
The illustration shows LEMO model.
DPR block
PS-934 board
Harness
PSW
3 x 6
3-17