Sony PXW-X500 Service Manual page 99

2-11. DPR-362 Board
Preparation
1. Remove the outside panel assembly. (Refer to
2. Remove the bracket (WA) assembly. (Refer to
3. Remove the inside panel assembly. (Refer to
4. Remove the DCP-67 board. (Refer to
5. Remove the HPR-53 board. (Refer to
Procedure
1. Disconnect the fine-wire coaxial cables and the coaxial cables.
1) Release the fine-wire coaxial cable from the clamper.
2) Disconnect the four fine-wire coaxial cables from the four connectors (CN2302, CN5201, CN5202, CN5400)
on the DPR-362 board.
3) Disconnect the three coaxial cables from the three connectors (CN SDI1, CN SDI2, CN SDI3) on the DPR-362
board.
Fine-wire coaxial cable
CN5400
Note
When connecting the coaxial cables, connect the coaxial cables to correct connectors.
PXW-X500
"2-2. Outside Panel
"2-6. Wi-Fi Module/SD-58
"2-3-1. Inside Panel
"2-9. DCP-67 Board")
"2-10. HPR-53 Board")
Fine-wire coaxial cable
DPR-362 board
CN5202
CN5201
CN2302
CN SDI3
CN SDI2
CN SDI1
Assembly")
Board")
Assembly")
Fine-wire coaxial cables
Clamper
Coaxial cable (White)
Coaxial cable (Gray)
Coaxial cable (Yellow)
2-45