Sony PXW-X500 Service Manual page 102

4. Remove the heat sink (HPR-B).
1) Remove the four screws to detach the heat sink (DPR-B).
2) Release the fine-wire coaxial cable from the clamper.
3) Disconnect the fine-wire coaxial cable from the connector (CN2300) on the DPR-362 board.
4) Remove the four hexagonal supports.
Clamper
Hexagonal supports
Fine-wire coaxial cable
Note
Pay attention to the following when installing the heat sink (DPR-B).
• Tighten the screws in the order of (a) to (d).
• In the case of dropping the radiation sheet, the radiation sheet C, radiation sheet 081015 and the radiation
sheets (L), attach their sheets at the location as shown in the following figure.
Radiation sheets (L)
(Stacked in pairs)
Radiation sheet (L)
Radiation sheet
(0707t3)
Radiation sheet 081015
5. Install the removed parts by reversing the steps of removal.
PXW-X500
PSW2 x 5
Radiation sheet D
(a)
PSW2 x 5
PSW2 x 5
(d)
(c)
CN2300
DPR-362 board
Radiation sheet (L)
PSW2 x 5
(b)
Heat sink (DPR-B)
DPR-362 board
Radiation sheets C
2-48