Sony PXW-X500 Service Manual page 111

3. Remove the IO board assembly.
1) Remove the three screws, and pull up the IO board assembly.
2) Disconnect the harness from the connector (CN5) on the IO-275 board.
3) Disconnect the fine-wire coaxial cable from the connector (CN001) on the IO-275 board, and remove the IO
board assembly.
CN5
(IO-275 board)
Harness
4. Remove the harness guard (CN BOX).
Harness guard
(CN BOX)
Note
When installing the harness guard (CN BOX), install it as shown in the figure.
PXW-X500
PSW2 x 5
DIF-232 board
IO-275 board
IO board assembly
CN001
(DIF-232 board)
Fine-wire coaxial cable
Harness guard
(CN BOX)
2-57