Transportation, Storage; Transport; Storage; Installation Preparations - Maico ERR Series Mounting And Operating Instructions

uk │ 5. Transportation, storage

5. Transportation, storage

5.1 Transport

Risk of injury during transport:
Unauthorised means of
transport or lifting gear may
CAUTION
result in the unit falling off.
1. Weight ( note technical data
and centre of gravity (centre).
2. Observe the maximum
permitted loading capacity
for lifting gear and means
of transport.
3. Do not stand under a
suspended load.
Risk of cuts from metal
housing plates with sharp
edges.
CAUTION
Wear protective gloves.
Risk of damage to unit if
NOTICE
means of transport are
incorrectly attached.
Do not place load on sensitive
components, such as an impeller
or terminal box.
Notes
●
Use appropriate means of transport for
transport purposes.
●
Maico accepts no indemnification or
warranty claims in the event of improper
transport.

5.2 Storage

●
Only store fan horizontally in a suitable,
dry room: ambient temperature - 10 to
+ 60 °C.
●
Before installing, check that the motor
bearing is working properly.
●
Maico accepts no liability for corrosion
damage caused by improper storage,
e.g. storage in a damp room.
14

6. Installation preparations

Risk of cuts from metal
housing plates with sharp
edges.
CAUTION
Wear protective gloves.
Notes
●
Avoid transmission of vibrations to the
duct system: Use flexible fixing cuffs
(type ELR) and a mounting foot (FUR).
●
Unpack fan unit. Dispose of packaging
material ( chapter 12).
●
Lay a permanent power cable to the
installation location.
●
With free inlet, fit a SGR type protective
grille appropriate for the unit.
●
Always note the relevant specifications
for electrical installations and when fitting
equipment. In Germany observe DIN
VDE 0100 and the corresponding parts
in particular.
1. With free inlet, drill 3 holes (see arrows) in
upper part of housing [7] for SGR protect-
tive grille and screw grille down with
3 tapping screws. Suitable mounting
material is to be supplied by the customer.
2. If duct system is already in place, cut
through folded spiral-seam duct at
installation location.
Note spacing for flexible fixing cuffs
(types ELR).