Table of Contents
Advertisement
To set the dosing volume tap on the '+' button in the top right corner. Then set the name of the
dosing plan and the time period to dose. It is factory set from 00:00 to 23:59 so that the dosing
volume will be added throughout the full day, it can set to dose for a limited period e.g. between
10:00 and 18:00. Once the times have been set tap 'Save' in the top right corner.
Select the 'Quick Add' tab. Enter the total amount that you would like to dose during the period
selected in the previous step and how many times to split that dose. For example, if the 'Total add' is
set to 10ml and the 'Add times' to 24 the pump would automatically split a 10ml dose in to 24 smaller
doses throughout the set period.
The number of times the dose can be split will be determined by the overall time period set for the
plan and the total volume to be dosed.
By tapping on the Eye logo next to the save button a detailed plan preview will be shown based on
the 'Add times' and 'Total add' figures. This will show when the pump will run and how much it will
add on each dose.
From here set the Anti-chemical interference can also be set. If you are using multiple P1 PRO dosing
pumps this can be used to prevent them dosing at the same time. The time set in here will delay the
automatically calculated program for that pump.
For example, if the two P1 PRO pumps are set to dose 10ml, between 12:00 and 23:00, over 8 doses
with the chemical interference set to '0', both will enter the first dose at 12:00 at the same time. They
will then continue to dose at the same time throughout the day until they complete their program. If
the chemical interference is set to '0' on the first pump and '3' on the second, the first pump will run
as described above but the second pump will start its first dose at 12:03 and then continue with an
automatically programmed 3 minutes delay on every dose.
When finished tap 'Save' in the top right corner to store the plan.
Finally set the amount of dosing solution available by tapping the dosing container volume. This gives
a real time estimate of how much and how many dosing days of solution are available. When the
dosing solution is low the icon will change to yellow.
The plan page will now show the completed settings.
7
Version 1.0
Advertisement
Table of Contents
