Replace Canister - Meiko TopLine Instructions For Use Manual

8.5

Replace canister

WARNING – Risk of injury from contact with chemicals
•
Use safety eyeware.
•
Wear protective gloves.
•
Observe the manufacturer of the dosing agent's applicable safety regulations
and safety data sheets.
•
Follow the manufacturer of the dosing agent's first aid measures in an emer-
gency.
*) MEIKO recommends hanging up a description of the first aid measures
near the machine.
Note
The canisters for the dosing agent are located in different places de-
pending on the appliance, see page 15.
1. Open the door or drawer.
3. Remove empty canister.
5. Connect the suction lance to the
canister. Suction lance must be
vertical in the canister.
7. Vent dosing system, see page 48.
Note
It is possible that rinse aids/water softeners other than those approved
by MEIKO have a lower calcium binding capacity. An unsuitable rinse
aid/softener may cause limescale to build up on heating elements and
on wash nozzles. The cleaning result may be affected.
When using a detergent from another manufacturer or a different dosing agent
variant, flush the complete detergent dosing system with water.
"In particular, chemicals and higher temperatures in the process, as well as me-
chanical loads when holding and transporting, can have a negative impact on
the washware."
9617722
2. Pull suction lance out of canister.
4. Insert new canister (still sealed),
then remove lid. The canister must
stand up straight.
6. Lock door with key.
34 / 60