Table of Contents
Advertisement
T
4.4 Commissioning
ATTENTION: For new or conserved units, the resin filter is removed from the unit and must be
inserted! See next page.
To start the HydroPower RO S, proceed as follows:
1. Connect the two hoses. Do not forget the concentrate hose at the
back of the unit.
2. Connect the power cord to the power supply.
3. Turn on the water supply
4. Put upper switch to the position „WORK"
5. Turn the lower switch from OFF > PURE to work with pure water.
6. The pre-filter cartridges must fill completely with water before
100% efficiency can be achieved.
The red RESTART button on the pump control on the back restarts
`
the pump in case of low pressure. As the system is only just filling
with water at this point, press the RESTART button until the filling
process for both filter cups is complete.
The excess air escapes through the water and concentrate outlets.
The HydroPower RO S is now ready for use.
3
Info: When you select „TAP BOOST", unfiltered tap water with
`
increased pressure comes out to flush surfaces and remove stuborn
dirt.
18
HydroPower® RO S
Commissioning
CAUTION
Slight injuries due to pressurized containers possible.
The 3 filter cartridges are pressurized during operation.
`
Never remove a filter vessel during operation.
`
Check if the hoses and tubes are water-tight and fit properly before
`
commissioning the system.
Use protective gloves.
`
www.ungerglobal.com
1
4
5
6
6
Advertisement
Table of Contents
