PIONEER DJ TSP-16 Service Manual page 45

5
PAGE 11 : AUDIO TEST
OFF
• Mode for confirmation of the Audio Route
• In MODE1
INPUT ---> output from OUT1-2/MASTER, OUT3-4, OUT5-6, OUT7-8 and PHONES
• In MODE2
INPUT ---> via SND DAC(IC6000)/RTN ADC(IC6001) ---> output from OUT7-8
• In MODE3
INPUT ---> via Analog Filter ---> output from OUT-1/2 and MASTER
• When LIMIT button is enabled (lit in green), execute a limiter by the hardware circuit to input line.
(In the case of gray will be limiter OFF)
* When the modes are switched, automatic fade-out / fade-in processing of sound volume is not carried out,
so the switching noise (popping sound) is output.
Before switching the modes, adjust the sound volume by turning OFF the volume of amplifier at output destination.
PAGE
12 : FACTORY RESET
• This is the mode for Factory Reset
• Resets the setting values of utilities etc. to the factory shipment status excluding a part of setting by pressing
RESET button.
* Setting that is not reset to the factory shipment status by factory reset
• PAD calibration
• Touch panel calibration
Setting of touch panel calibration that is set in the Test Mode is not reset to the factory shipment status
even if the factory reset is executed.
Setting of touch panel calibration that is set for utilities is reset to the factory shipment status if the factory
reset is executed.
• Language setting
5
6
[PAGE 11] AUDIO TEST
MODE1 MODE2
[PAGE 12] FACTORY RESET
RESET
TSP-16
6
7
MODE3 LIMIT
7
8
A
B
C
D
E
F
45
8