PIONEER DJ TSP-16 Service Manual page 43

5
PAGE 6 : ENCODER TEST
PUSH ENCODER
PUSH ENCODER STATUS : [ON, OFF]
6 ENCODER (1)
6 ENCODER (2)
6 ENCODER (3)
6 ENCODER (4)
6 ENCODER (5)
6 ENCODER (6)
PAGE 7 : TOUCH PANEL TEST
• Check using a touch pen with small tip is recommended
• Mode for checking the accuracy of touch point.
• If you touch squares at four corners shown above, they will become blue.
If you touch all squares, check result will become OK.
• If you press REC button, mode will shift to the calibration mode.
While touching the center of + mark of red square in the upper left, press REC button.
While touching the center of + mark of red square in the upper right, press REC button.
While touching the center of + mark of red square in the lower left, press REC button.
While touching the center of + mark of red square in the lower right, press REC button. Calibration will be completed.
(If the calibration is completed by pressing REC button without touching it, calibration value will be discarded.
Touch motion will be operated without calibration.)
* Calibration of the touch panel, carried out only at the time of check NG.
5
6
[PAGE 6] ENCODER TEST
:
: 0
: 0
: 0
: 0
: 0
: 0
•
• PUSH ENCODER also displays the status when
ENCODER(1) ENCODER(6)
[PAGE 7] TOUCH PANEL TEST
Touch dots
TSP-16
6
7
PUSH
ENCODER
Mode for confirmation of the Encoders
it is pushed.
When it is pushed, "ON" is displayed. When it is
not pushed, "OFF" is displayed.
7
8
A
B
C
D
E
F
43
8