PIONEER DJ TSP-16 Service Manual page 41

5
PAGE 2 : LED TEST(2) - ALL OFF
[PAGE 2] LED TEST(2) - ALL OFF
PAGE 3 : PAD CALIBRATION MODE
PAD13
PAD9
PAD5
PAD1
* If PAD calibration has not been carried out, PAD unexecuted will blink red.
[Calibration method for service]
• Mode for calibrating PAD.
• Raw AD value of PAD is displayed at "
• Calibration value is displayed at "
If it is not set, "---" is displayed.
• 3 times the value of calibration is displayed at "ooo".
If it is not set, "---" is displayed.
• If you keep touching "RESET" GUI button for five seconds or more, calibration data of 16 PADs can be initialized.
If you carry out the calibration again when this unit is disassembled or parts are replaced with new ones, initialize the data, and then
carry out the calibration.
• After the jig is set, press "WAKE UP" hard button in the upper right of the control panel. Then, measurement and recording will be started.
After spare period of three seconds, obtained average value will be saved in the main unit in one second average value acquisition period.
Measurement is carried out three times and average value will be adopted as the calibration value.
• Valid calibration value range is 48 or more to 504 or less.
• Calibration value at " " will be overwritten if the new value is within the effective value range shown above.
Other value will be recognized as invalid value and it is not recorded in the main unit.
Note) If you want to weight to PAD, Weighting Jig convex portion(
it is placed so as not to deviate from the center of PAD.
5
6
[PAGE 3] PAD Calibration mode
PAD14 PAD15
ooo ooo
ooo ooo
PAD10 PAD11
ooo ooo
ooo ooo
PAD6 PAD7
ooo ooo
ooo ooo
PAD2 PAD3
ooo ooo
ooo ooo
".
".
Not deviate from
center of PAD
6
7
• Mode for making All LEDs Light Off.
• Immediately after the mode are switched,
characters will disappear and LCD display
will become black.
PAD16
ooo ooo
ooo ooo
PAD12 START
ooo ooo
ooo ooo
PAD8
ooo ooo
ooo ooo
RESET 5s
PAD4
ooo ooo
ooo ooo
φ
12", ground plane(
Weighting Jig
TSP-16
7
8
φ
10") is down ),
Performance PAD Section
8
A
B
C
D
E
F
41