ATEN Altusen KL1116L User Manual page 20

KL1116 User Manual
No. Component
4 Port Switches Press a switch to bring the KVM focus to the computer
and Port LEDs attached to its corresponding port. See p. 25 for details.
Two Port LEDs are built into the Port Switches. The one on
the left is the On Line LED; the one on the right is the
Selected Port LED:
! An On Line LED lights GREEN to indicate that the
computer attached to its corresponding port is up and
running.
! A Selected LED lights ORANGE to indicate that the
computer attached to its corresponding port is the one
that has the KVM focus. The LED is steady under normal
conditions, but flashes when its port is accessed under
Auto Scan Mode (see p. 42).
5 Keyboard
6
Touchpad
7 Lower Handle Pull to slide the keyboard and touchpad module out. See
item 1 in this table and p. 15 for more details on sliding the
console in and out.
8
Power LED Lights BLUE to indicate that the unit is receiving power.
9 Lock LEDs & ! The Num Lock, Caps Lock, Scroll Lock LEDs are located
Reset Switch here.
! A Reset Switch is located just to the right of the Lock
LEDs. Press this recessed switch in with a thin object to
perform a system reset.
10 Release Catch These catches (one on each side of the keyboard) release the
keyboard and touchpad module so you can slide it away.
11 Firmware ! Firmware Upgrade Port: The Firmware Upgrade Cable
Upgrade that transfers the firmware upgrade data from the
Section administrator's computer to the KL1116 plugs into this
RJ-11 connector.
! Firmware Upgrade Switch: During normal operation
this switch should be in the NORMAL position. (See p. 53
for firmware upgrading details.)
12 Rack Mounting The rack mounting tabs located at each corner of the unit
Tabs secure the chassis to a system rack. Refer to the Appendix
(p. 64), for rack mounting details.
6
Description
2005-11-04