Fcc Statement - ETEKCITY TMB-1583-BS User Manual

Attributions
iOS is a registered trademark of Cisco Systems, Inc.
and/or its affiliates in the United States and certain
other countries.
Apple App Store is a trademark of Apple Inc.
Android, Google Home and Google Play are
trademarks of Google LLC.
Amazon, Echo, and all related logos are trademarks
of Amazon.com, Inc. or its affiliates.
The Bluetooth word mark and logos are registered
®
trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Etekcity Corporation is under
license.
42

FCC Statement

FCC ID: OU9TMB1583BS
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate this equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End users must follow
the specific operating instructions for satisfying RF exposure
compliance. To maintain compliance with FCC RF exposure
compliance requirements, please follow operation instructions as
documented in this manual. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum
distance of 20 cm between the radiator and your body. The
availability of some specific channels and/or operational frequency
bands are country dependent and are firmware programmed at the
factory to match the intended destination. The firmware setting is
not accessible by the end user.
43