Table of Contents
Advertisement
UUT PAGE (Page 2 of 2)
1.
Enter the UUT Part Number.
2.
Enter the UUT Model.
3.
Enter the UUT Manufacturer.
4.
Enter the required pressure Settling Time at target (in milliseconds, 99,999 max. and 0 min,
5,000 recommended.) Pressure settling time is time allowed at pressure point before data
is acquired.
5.
ENTER MAXIMUM LEAK RATE in box. This is PASS/FAIL criteria for leak check function,
measured in change of pressure per second.
6.
Enter the required pressure stability for data acquisition in the Control Stability field.
7.
Enter the System Volume value. 64 is default. To increase speed of pressure control,
increase this value. The software automatically programs this value based on testing
performed at Setra. It is recommended that the preprogrammed values always be used.
8.
To accept the changes made, tap SAVE. To reject the changes made, select new profile.
26
Advertisement
Table of Contents
Need help?
Do you have a question about the MicroCal and is the answer not in the manual?