Uut (Unit Under Test) Setup: General - Setra Systems MicroCal User Manual

Advanced modular pressure calibrator

Table of Contents

6.5 UUT (UNIT UNDER TEST) SETUP: GENERAL

Screen Instructions (Diagram 15):

UUT setup screeen is used for inputing UUT profiles into the UUT database.

Select an Existing Profile - Go to the UUT ID drop down box, click the down arrow and select

your unit from the list.

Create a New Profile - Tap NEW button on right of page, a dialog box will appear prompting

user to enter new UUT ID. Enter new ID in the box and select UUT to copy if desired from

drop down list below.

Press OK to create the new profile or CANCEL to cancel action.

Note: To automatically setup a UUT using Setra's configurable part number, simply enter the Setra

part number as the new ID, then press "OK". If the number entered is a valid configurable number,

the UUT will be automatically setup.

Enter the UUT's Serial Number in the field provided.

In the Accuracy field, enter the pass/fail accuracy for the UUT.

In the recal Accuracy field, enter an accuracy (greater than the one entered in the Accuracy

field) at which you would like the calibrator to recal the transducer in spite of a passing

result.

Note: Only use with Setra 269. This feature is for automated calibrations, is optional and can

be useful for transducers that have drifted, but are not yet failing, by avoiding a failing result at the

next calibration.

Enter the transducer's lowest and highest pressure in the LOW and HIGH boxes in the Input

column.

Enter the transducers corresponding lowest and highest output in the LOW and HIGH boxes

in the Output column.

Select Test Profile from drop-down list or create a new one (save UUT, go to PROFILE page

and create NEW, return to UUT and select newly created profile for default profile and press

SAVE).

Select Excitation Level from drop down list.

10. Select UUT Type from drop down list, (See Page 28 for UUT Type details.)

11. Save - Once all parameters have been changed, tap the SAVE button at bottom.

button will be 'grayed out' when data has been saved

12. Delete - Select UUT from list of available UUT ID's at the top of the screen. Tap DELETE

button at bottom of the page.

13. More - Press to access remaining UUT setup items.

Note: Save

Table of Contents

Do you have a question about the MicroCal and is the answer not in the manual?