Programme Duration; Delay Start Button; Programme End; Pausing The Machine - Candy WashPass Manual

l
To start the selected cycle with the preset
parameters, press PLAY/PAUSE. When
the programme is running, the display will
show the time to elapse.
l
Moreover, If you want to modify the
chosen program,
options buttons,
parameters and
PAUSE button to start the cycle.
Only the options compatible with the
set programme can be selected.
l
After switching on the appliance, wait a
few seconds for the programme to start
running.

PROGRAMME DURATION

l
When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
l
Once the programme has started you will
be kept informed constantly of the time
remaining to the end of the wash.
l
The appliance calculates the time to the
end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to that
applicable to the size and composition of
the load.

PROGRAMME END

l
"END" will appear in the display at the
end of the program and the DOOR
LOCKED light will go off, it is now
possible to open the door.
l
At the end of the cycle, turn off the
washing machine by turning the SMART
RING to the OFF position.
The SMART RING must ALWAYS be
put in the OFF position at the end of
the washing cycle before you can
select a new washing cycle.
press the desired
modify the default
then press PLAY/

PAUSING THE MACHINE

l
Keep the PLAY/PAUSE button pressed
for about 2 seconds (some light indicators
and the residual time display will flash,
showing that the machine is paused).
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
l
Press the PLAY/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, turn the
SMART RING to the OFF position.
l
Wait until the DOOR LOCKED light has
gone out before opening the door.

DELAY START button

l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
l
To delay the start use the following
procedure:
- Select the required programme.
- Press the delay start button once to
activate it (h00 appears on the display)
and then press it again to set a 1 hour
delay (h01 appears on the display). The
pre-set delay increases by 1 hour each
time the button is pressed, until h24
appears on the display, at which point
pressing the button again will reset the
delay start to zero.
13