Table of Contents
Advertisement
Number of teeth ................................. 24 - 60
Table size ................................ 642x 487 mm
Table width extension, left/right ................. 642 x 225 mm
Cutting height max. ..................... 85 mm / 90°
..................................................... 65 mm / 45°
Height adjustment ............... infinite 0 -85 mm
Tilting saw blade ...................... infinite 0 - 45°
Extractor socket ............................... Ø 35 mm
Weight ....................................... approx. 22 kg
Operating mode S6 25%: Continuous operation with idling (cycle time 10 minutes). To ensure that the
motor does not become excessively hot, it may only be operated for 25% of the cycle at the specifi ed
rating and must then be allowed to idle for 75% of the cycle.
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
LpA sound pressure level ...............91 dB(A)
KpA uncertainty ........................................ 3 dB
LWA sound power level ................. 104 dB(A)
KWA uncertainty ....................................... 3 dB
The quoted values are emission values and not necessarily reliable workplace values. Although there
is a correlation between emission and im-mission levels it is impossible to draw any certain
conclusions as to the need for additional precautions. Factors with a potential influence on the actual
immission level at the workplace include the duration of impact, the type of room, and other sources of
noise etc., e.g. the number of machines and other neighboring operations. Reliable workplace values
may also vary from country to country. With this information the user should at least be able to make a
better assessment of the dangers and risks involved.
Wear earmuffs.
The impact of noise can cause damage to hearing. Keep the noise emissions and vibrations Keep the
noise emissions and vibrations to a minimum.
• Only use appliances which are in perfect working order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in accordance with instructions, certain residual risks
cannot be rules out. The following hazards may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask is used.
2. Damage to hearing if no suitable ear protection is used.
5. Before starting the equipment
Before you connect the equipment to the mains supply make sure that the data on the rating
plate are identical to the mains data.Warning! The maximum permissible system impedance is 0.340Ω
at the interface point of the user's supply. The manufactory should declare it in the equipment
instruction manual
and instruct the user to determine in consultation with the supply authority, if necessary, that the
equipment is connected only to a supply of that impedance or less.
© by WilTec Wildanger Technik GmbH
Seite 32
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
