Table of Contents
Advertisement
• Important! Pull out the power plug first.
• Remove the table insert by undoing the two countersunk head screws (see 6.4).
• Undo the nut with a size 24 wrench on the nut itself and a second fork wrench (size 10) on the motor
shaft to apply counter-pressure.
• Important! Turn the nut in the direction of rotation of the saw blade.
• Take off the outer flange and pull the old saw blade off the inner flange by dropping the blade at an
angle.
• Clean the blade flange thoroughly beforefitting the new blade.
• Mount and fasten the new saw blade inreverse order.
• Important! Note the running direction. The cutting angle of the teeth must point in running
direction, i.e. forwards (see the arrow on theblade guard).
• Refit and set the splitter (5) and the saw guard (2) (see 6.2., 6.3.)
• Check to make sure that all safety devices are properly mounted and in good working
condition before you begin working with the saw again
6.6 Assembling the table width extension
(Fig. 18)
• Use the screws (a), nuts (d) and washers (c) to fasten the table width extensions (33) loosely to the
saw table (1).
• Screw the supports (32) loosely onto the saw housing and onto the table width extensions (33).
• Align the table width extensions (33) level with the saw table.
• Finally, tighten all screws (a).
7. Using the saw
7.1. ON/OFF switch (Fig. 1)
• To turn the saw on, press the green button
"I". Wait for the blade to reach its maximum
speed of rotation before commencing with the
cut.
• To turn the machine off again, press the red
button "O".
7.2. Cutting depth (Fig. 1)
Turn the hand crank (8) to set the blade (4) to the required cutting depth.
Turn anti-clockwise:
larger cutting depth
Turn clockwise:
smaller cutting depth
7.3.1. Stop height (Fig. 9-13)
• The parallel stop (7) supplied with the benchtype circular saw has two different guide faces.
• For thick material you must use the stop rail (23) as shown in Fig. 11, for thin material you
must use the stop rail as shown in Fig.10.
• To change over the stop rail (23) to the lower guide face you have to slacken the two knurled screws
(26) in order to disconnect the stop rail (23) from the holder (24).
• Remove the two knurled screws (26) through the one slot (27) in the stop rail (23) and insert in the
other slot (25).
• Remount the stop rail (23) on the holder (24).
• The procedure for changing over to the highguide face is similar.
7.3.2. Cutting width:
• The parallel stop (7) has to be used when making longitudinal cuts in woodenwork pieces.
• The parallel stop (7) can be mounted on either side of the saw table (1).
• The parallel stop (7) has to be mounted in the guide rail (28) of the saw table (1).
• The parallel stop (7) can be set to the required dimension with the help of the scale
(22) on the guide rail (1).
© by WilTec Wildanger Technik GmbH
Seite 34
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
