Table of Contents
Advertisement
10. Connect the dust extraction device if you will be processing wood, materials similar to
wood, or plastics.
– If connections for dust extraction and a collect-ing device are present, make sure that
they are connected and used properly.
– When processing wood, materials similar to wood, and plastics. operation in enclosed spaces is only
permitted with the use of a suit-able extraction system.
11. Secure the workpiece
– Use the clamping devices or a vice to hold the workpiece in place. In this manner, it is held more
securely than with your hand.
– An additional support is necessary for long work-pieces (table, trestle, etc.) in order to prevent the
machine from tipping over.
– Always press the workpiece firmly against the working plate and stop in order to prevent
bouncing and twisting of the workpiece.
12. Avoid abnormal posture
– Make sure that you have secure footing and always maintain your balance.
– Avoid awkward hand positions in which a sudden slip could cause one or both hands to come into
contact with the saw blade.
13. Take care of your tools
– Keep cutting tools sharp and clean in order to be able to work better and more safely.
– Follow the instructions for lubrication and for tool replacement.
– Check the connection cable of the electric tool regularly and have it replaced by a recognised
specialist when damaged.
– Check extension cables regularly and replace them when damaged.
– Keep the handle dry, clean and free of oil and grease.
14. Pull the plug out of the outlet
– Never remove loose splinters, chips or jammed wood pieces from the running saw blade.
– During non-use of the electric tool or prior to maintenance and when replacing tools such as saw
blades, bits, milling heads.
– When the saw blade is blocked due to abnormal feed force during cutting, turn the machine off and
disconnect it from power supply. Remove the work piece and ensure that the saw blade runs free.
Turn the machine on and start new cutting operation with reduced feed force.
15. Do not leave a tool key inserted
– Before switching on, make sure that keys and adjusting tools are removed.
16. Avoid inadvertent starting
– Make sure that the switch is switched off when plugging the plug into an outlet.
17. Use extension cables for outdoors
– Only use approved and appropriately identified extension cables for use outdoors.
– Only use cable reels in the unrolled state.
18. Remain attentive
– Pay attention to what you are doing. Remain sensible when working. Do not use the electric tool
when you are distracted.
19. Check the electric tool for potential damage
– Protective devices and other parts must be carefully inspected to ensure that they are fault-free and
function as intended prior to continued use of the electric tool.
– Check whether the moving parts function fault-lessly and do not jam or whether parts are damaged.
All parts must be correctly mounted and all conditions must be fulfilled to ensure fault-free operation of
the electric tool.
– The moving protective hood may not be fixed in the open position.
© by WilTec Wildanger Technik GmbH
Seite 27
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
