Table of Contents
Advertisement
CombiLineBloc
1.5.3
!
1.5.4
1.5.5
1.6
➢
CLB/EN (1901) 6.6
Hoisting
When lifting a complete pump unit always use a proper and sound lifting
device, approved to bear the total weight of the load!
Never go underneath a load that is being lifted!
If the electric motor is provided with a lifting eye, this lifting eye is intended
only for the purpose of carrying out service activities to the electric motor!
The lifting eye is designed to bear the weight of the electric motor only!
It is NOT permitted to lift a complete pump unit at the lifting eye of an electric
motor!
Opening the packaging
The pump may be packed in a cardboard box with wooden bottom. The boxes are kept
shut by 2 plastic straps. These straps also serve to keep the bottom and the covering box
together.
Always make sure that the box stands on the floor!
Wear gloves: the straps are under tension and may be sharp!
1 Cut the plastic straps.
2 Remove the covering box.
3 Unscrew the pump from the bottom.
4 Rest the pump on the supporting brackets under the suction bend.
Storage
If the pump is not to be used immediately the stub shaft must be turned by hand twice
per week.
Ordering parts
This manual contains a survey of the spare parts recommended by SPXFLOW as well as
the instructions for ordering them. A fax-order form is included in this manual.
You should always state all data stamped on the type plate when ordering parts and in
any other correspondence regarding the pump.
This data is also printed on the label on the front of this manual.
If you have any questions or require further information with regard to specific subjects,
then do not hesitate to contact SPXFLOW.
Introduction
11
Advertisement
Table of Contents
