Table of Contents
Advertisement
16 of 20... 8700 SERIES REMOTE CONTROL
c)
X
This option allows you to use the chronometer of the remote to measure the time between two
consecutive pulsations of the key GO of the crossfader. The chronometer always is active, and
is restarted each time you press
line. In the software key, we will see
If the chronometer is active, the navigator tricolour LED blinks in orange.
REC
It is possible to disable the functions rec and MDFY, preventing the recording or modification of
cues by mistake, from the remote control. The configuration options are:
enable (activated functions) and
disable (deactivated functions).
If these functions are deactivates the navigator tricolour LED is lit in red.
Leds Level
It allows you to adjust the brightness of the keyboard LEDs; to less brightness, less consumption.
BACKLIGHT Lev
It allows you to adjust the brightness of the display; to less brightness, less consumption.
Status for the tricolour LED of the navigator
Function / Status
Battery charge level < 35%
Display turned off
Chronometer enable and active
REC key disable
HRC activated in normal mode
The tricolour LED always shows us the status of more high priority. If 2 status or functions of the previous
table there is at the same time, in the LED only you can see the status of more priority.
Example: If the remote has the chronometer activated and the display is at off, the LED will be blinking in
green (display off condition).
POWER OFF & AUTO-POWER OFF
The remote must be turned off, always, pressing OFF.
In this way, the remote can to store all data of its setup.
With the objective to conserve the battery, the remote-radio, according to charge of its battery and use:
1. They are powered off, automatically, when the battery this less than the 25%
2. They are powered off, automatically, when in the remote no keys are pressed during 10 minutes.
This process is to avoid excessive battery consumption. Although, after the first minute, the display
light yet is powered off.
RESET
In the rear part of the remote control we find the RESET push button,, necessary to power off the remote in
cases of software failure. To activate this push button is necessary to do it introducing the point of a pencil, or
other similar element, by the hole.
When is a Reset needed?
In the presence of an electrostatic discharge, or a electromagnetic noise (of energy bigger than the permitted)
the micro-controller can bear. In this case is enough to do a Reset.
or GO. The last measured value is showed in the message
X
Tricolour LED in HRC-wireless
BLINK IN RED
BLINK IN GREEN
BLINK IN ORANGE
AT ON IN RED
AT OFF
LEVITON 8700 SERIES
Tricolour LED in HRC-cable
-- --
-- --
BLINK IN ORANGE
AT ON IN RED
AT OFF
Advertisement
Table of Contents
