Assembly/Disassembly And Adjustments - Vermeiren Goliat User Manual

4 Assembly/disassembly
and adjustments
CAUTION
Assemble the rollator completely, before
adjusting its height.
4.1 Assembly
4.1.1 Mounting the front and rear wheels
CAUTION
Always set the four wheels to the same
height.
When mounting the rear wheels, check
that the brake cable connection (4) is
positioned to the inside of the rollator.
1. Put the rollator on the front/back.
2. Press and hold the spring button (1) on
the wheel support.
3. Slide the wheel support (2) into the frame
tube (3) until the spring button pops out of
the desired adjustment hole.
4. Repeat for the other wheels. Make sure
that all four wheels are well secured.
1
3
2
4
4.1.2 Mounting the handgrips
1. Place the rollator on four wheels. Make
sure that it is standing stable.
2. Push and hold the spring button (5) on the
handgrip.
3. Slide the handgrip into the frame tube (6)
until the spring button pops out of the
desired adjustment hole.
4. Repeat for the second handgrip. Make
sure that both handgrips are well secured,
and that they are set to the same height.
Risk of injuries
Risk of falling or
tipping over
1
3
6
Cable clamps
To prevent the cable from being trapped
between moving parts of the rollator, secure
the brake cable to the frame using the cable
clamp (7).
4.1.3 Mounting the storage bag
CAUTION
Do not overload the storage bag.
2
The maximum carrying weight of the storage
bag can be found in §7.
The storage bag is meant to be mounted
below the seat, on the two horizontal tubes on
which the seat rests.
1. Fold the seat (8) open.
2. Mount the storage bag on the frame tubes
with the five snap fasteners (9).
3. Fold the seat down again.
3
Goliat
2020-07
5
7
Risk of falling or
tipping over
8
9
EN
NL