Network Configuration - Fermax MEET MILO DIGITAL PANEL Installer Manual

 TIME ZONE: Setting the time zone of panel. Select local time zone and save.
 DAYLIGHT SAVING TIME: Shall be enabled for DST periods and disabled for wintertime.
NOTES:
If the installation has FERMAX MANAGEMENT SOFTWARE, the date and time of panel will
synchronize automatically with the management software. If the panel has access to internet, the
date and time of panel will also synchronize with internet time server.
If the installation has no FERMAX MANAGEMENT SOFTWARE the installer can set date, time and
time zone manually. Do not use the GMT (TIME ZONE) adjustment in this case. GMT is usable only
when the time is automatically taken from internet or FERMAX MANAGEMENT SOFTWARE.
Date and time cannot be saved after power loss unless there were internet or management
software in the installation. However, the time zone, date format and daylight-saving time can be
saved anyway.
Pay attention to the SAVE button related to panel settings or date/time settings since are different
and independent.

2.3 NETWORK CONFIGURATION

Allows the configuration of the different parameters of the LAN network
 IP: IP address to be assigned to this panel.
 MASK: Subnet mask corresponding to the LAN
 GATEWAY: LAN gateway
 DNS: DNS server address. In case of doubt, we recommend using the default value 8.8.8.8.
 SOFTWARE IP: IP address of the PC where the MEET Management Software is installed (if any).
9