Fermax MEET MILO DIGITAL PANEL Installer Manual page 18

3. The first cell (A1) has the content: APARTMENT, NAME,
Do not change it.
4. Use the following cells (A2, A3, A4, etc.) to fill in the data of the devices to divert.
Depending on the type of call, the format of the data is different:
a. IN the case of a call to a FERMAX MEET ME LICENCE:
APARTMENT, sip: XXXXXXX@sip.fermax.com were XXXXXXX is the licence name and
APARTMENT is the number to dial in the panel
b. IN the case of a call to a MEET device in the same installation:
APARTMENT, sip:XXX@IP_DEVICE where XXX is any identifier of the device and
IP_DEVICE is the IP address to the MEET monitor to call.
c. In the case of a call to a third party SIP device (through a SIP server):
APARTMENT, sip:user@IP_SIP_SERVER where user is the identification user that the
device to call has been programmed in the SIP server, and IP_SIP_SERVER is the IP of
the SIP server.
d. It is also possible to assign multiple and different divert formats to the same
apartment (for example a call to a third-party SIP device and a smartphone device as
well).
Use the corresponding format explained above, using the same row but different
column for each format. See example below.
5. Once the table has been finished, save it and import to the panel. For this, click on "Choose
file", select the file to import and click on IMPORT button.
Wait for a few seconds until a pop-up message "UPLOAD SUCCESS" appear.
EXAMPLE
18