Bausch Datacom DinBox RTU M4 Reference Manual page 38

5.2 Configuration via the serial interface
Use the standard Bausch Datacom 'white' RJ45 to DB9 serial cable to connect to the
serial interface DinBox RTU
with RTS/CTS flow control enabled.
This interface is used to debug the
During startup some basic information is sent.
...
15:24:30 (INFO) **********************************
15:24:30 (INFO) *** DinBox RTU M4 ***
15:24:30 (INFO) **********************************
15:24:30 (INFO) Copyright: 2019 Bausch Datacom NV
15:24:30 (INFO) Version: v1.3-16-g91a23bf
15:24:30 (INFO) Compiled: Jun
15:24:30 (INFO) Target: STM32F437 : Bank 1
15:24:30 (INFO) starting picoTCP...
15:24:30 (INFO) picoTCP stack initialized
15:24:31 (INFO) WM: 104 Server
15:24:41 (INFO) HL module up and running
15:25:00 (INFO) WAN IP address: 10.35.0.10
Via the Administration-Traces page it's possible to enable trace information about
a specific functionality.
Via proprietary at-commands it's possible to configure, test or debug the
M4.
To gain full access a login in needed:
at#login
Username:admin
Password:********
OK
After 3 minutes if no serial activity the interface will automatically logout.
To see all the possible commands:
at#?
Bausch M4 command set:
1. at#?
2. at#info
3. at#gcfg
4. at#gbank
5. at#gwanip
6. at#rst
7. at#defaults
8. at#get#
9. at#set#
10. at#test
11. at#ftp
M4. The asynchronous parameters are 115.200 bps 8N1
DinBox RTU
7 2019 10:30:17
M4.
DinBox RTU