Related Manuals for Bausch Datacom DinBox GSM M4
Summary of Contents for Bausch Datacom DinBox GSM M4
- Page 1 Hardware Configuration Manual DinBox GSM M4 V1.0 Bausch Datacom NV Tiensesteenweg 54 B-3360 Korbeek-Lo Belgium info@bausch.be – www.bausch.be...
- Page 2 Bausch Datacom NV can not guarantee the safety if the DinBox GSM M4 is not used within the specifications described in this manual. Installation and service by qualified personnel only. Document History Date Version Auteur 01/05/24 V0.9 Preliminary Filip Lavaerts...
-
Page 3: Table Of Contents
Table of Contents Introduction Block Diagram Specifications Housing and Connectors Environmental conditions Power Supply Specifications SIM Card Interfaces and Connectors Power Connection DTE Interfaces Isolated RS-485 connection Non-isolated RS-232 connection Ethernet interface Antenna connection LED Indicator Configuration & Setup EC-declaration of conformity... - Page 4 Serial flow as used in this manual : Data Data Communication Terminal Equipment Equipment Modem DinBox GSM M4 Communication Application device Disconnect the mains power before opening the DinBox GSM M4 modem enclosure!
-
Page 5: Introduction
Introduction This manual is the reference when setting up the DinBox GSM M4 modem for your application. Because of the nature of this product and its field of application, some degree of technical background knowledge regarding the application and data- communication is assumed. -
Page 6: Block Diagram
The most important blocks are briefly described. DC power supply The DinBox GSM M4 has a non-isolated DC voltage power input. This supply must be connected to the DinBox GSM M4 modem via a 2 pin terminal block with screw contacts. - Page 7 GSM module The DinBox GSM M4 is using a Sierra Wireless CF footprint GSM module as WAN device. Thanks to the Sierra Wireless CF HL footprint for the WAN module, the DinBox GSM M4 offers the flexibility to easily migrate communication technologies, thus making it future proof.
-
Page 8: Specifications
- Flame retardant UL 94V-0 - Dimensions: 107.5x75x22.5mm (LxHxW) Mounting - standard DIN rail, with snap-in foot - the DinBox GSM M4 must be mounted vertically on a flat surface within a height of maximum 2 meters above the floor level. Connectors - power plug (screw connector) has a pitch of 3.81 mm... -
Page 9: Sim Card
How to install the SIM card: 1. Disconnect the power and DTE & LAN interfaces. 2. Open the DinBox GSM M4 enclosure. 3. The SIM cardholder is placed in the middle onto the PCB. 4. Slide (UNLOCK) the upper part of the SIM cardholder to open the holder. -
Page 10: Interfaces And Connectors
Before you start the installation, take a moment to become more familiar with the possible connections to and from the DinBox GSM M4 modem. The DinBox GSM M4 has three types of connectors; a mains terminal block screw connector, two RJ-45 connectors and one FME connector. -
Page 11: Power Connection
Always disconnect the mains power before connecting or disconnecting the DC power plug. Make sure the voltage supplied to the modem is within range of the DinBox GSM M4 input voltage (see specifications for details on voltage range above). - this power supply input is polarity protected... -
Page 12: Ethernet Interface
Ethernet interface This 10/100 Mbit/s LAN interface is primarily used to configure the DinBox GSM M4. Default IP address is 192.168.1.44 / 255.255.255.0. HTML is available on standard port 80. Antenna interface The GSM antenna must be connected on the GSM modem via a cable, depending on the application and the GSM RF field strength at the site. -
Page 13: Led Indicator
LED Indicators There is one RGB status LED located onto the front of the DinBox GSM M4 modem. green RSSI: Received Always ON : +CSQ==99 Signal Strength, 1 periodical flash: +CSQ >10 indicating the 2 periodical flash: +CSQ 10-14 received power level. -
Page 14: Configuration & Setup
7 Configuration & Setup Configuration of the DinBox GSM M4 can be done through a GUI via HTML. The default ip address of the modem is 192.168.1.44. Username : admin Password : password Click on “login” to enter the configuration pages of the modem. -
Page 15: Ec-Declaration Of Conformity
EC-Declaration of conformity tbd.
Need help?
Do you have a question about the DinBox GSM M4 and is the answer not in the manual?
Questions and answers