Preparing The Graphics Card; Removing The Stock Cooler; Removing The I/O Cover - ekwb EK-Quantum Vector Trinity RTX 3080/3090 User Manual

Gpu water block
Hide thumbs Also See for EK-Quantum Vector Trinity RTX 3080/3090:
Table of Contents

Advertisement

PREPARING THE GRAPHICS CARD

You will need the following tool:
Phillips Head Screwdriver
STEP 1

REMOVING THE STOCK COOLER

Use the Phillips head screwdriver to remove the six marked screws
STEP 1
from the side of the backplate.
Carefully detach the PCB together with the backplate from the stock
cooler and disconnect four cables connected to the PCB.
STEP 2

REMOVING THE I/O COVER

Use the Phillips head screwdriver to remove the two screws from the
side of the backplate and three screws from the I/O side. Put the I/O
cover aside - you'll need it later.
STEP 2
- 7 -
Always remove the stock cooler slowly - it might be firmly
glued to the PCB with thermal pads.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EK-Quantum Vector Trinity RTX 3080/3090 and is the answer not in the manual?

Table of Contents