Attaching The I/O Cover; Checking For Contact - ekwb EK-Quantum Vector Trinity RTX 3080/3090 User Manual

Gpu water block

Hide thumbs Also See for EK-Quantum Vector Trinity RTX 3080/3090:

Table of Contents

If necessary, temporarily remove the water block to check for

uniform surface contact between the block and components.

Pay special attention to the VRM section of the graphics card.

Check whether the water block makes contact with the intended

integrated circuit. Then repeat Steps from the previous section to

re-attach the block.

In case you fail to obtain good contact, please check again or contact

our support service at https://www.ekwb.com/customer-support/.

M2.5 x 6 AX1 SCREW

PVC WASHER

STEP 3

ATTACHING THE I/O COVER

After attaching the water block, carefully position the I/O cover

onto the graphics card while ensuring the holes are aligned. Use

two (2) M2.5 X 6 AX1 screws and PVC washers to secure the I/O

cover to the PCB.

- 12 -

Table of Contents

Do you have a question about the EK-Quantum Vector Trinity RTX 3080/3090 and is the answer not in the manual?